I've searched Cisco high and low for a document that outlines how I go about upgrading an ASA 5500 pair running in active/standby mode, from 7.1 to 7.2 code. Seems like it should be a simple task but I can't seem to find it. I need an example of how to do it via the CLI and the different options I may have. Thanks
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...