1) is correct the translation of config from 8.2 to 8.3???
2) In this object-group DM_INLINE_NETWORK_57 group the network object is refered to he first or the second object network obj-10.27.0.0? i must delate one of the two object network obj-10.27.0.0??? (in 8.3 config)
3) also for the object obj-192.168.104.157 in the ACL the destination obj-192.168.104.157 is referred to the first or second object obj-192.168.104.157 ??? i need to delete one of this two network obj-192.168.104.157 ????
Thanks a lot vary much.....for any question write to me..thanks a lot best regards
Th inside_access_in access-list is used only for restricting inbound traffic on the inside interface.The NAT in 8.3 does not make use of access-lists.
The two instances each that you see of object network obj-10.27.0.0 and obj-192.168.104.157 are the same - one denotes the network object and the other the auto-nat statement. You need not delete any of the instances.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...