Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Help setting up static NAT with multiple external IPs using 9.0.3?

Sorry for the trivial question, but I can't seem to figure out setting up NAT with multiple external IPs (e.g. 1.1.1.3 - 1.1.1.7). I have my outside inteface set to 1.1.1.7, however how do I allow say RDP (tcp 3389) being sent to 1.1.1.3 to be forwarded to 10.0.1.253 on my internal network? Attached is my current config.

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

Hi,Modified your ACL, apply

Hi,

Modified your ACL, apply this it should work 

no access-list outside_access_in extended permit object RDP any object HyperV 
access-list outside_access_in extended permit tcp any object HyperV eq 3389

 

HTH

Sandy

1 REPLY

Hi,Modified your ACL, apply

Hi,

Modified your ACL, apply this it should work 

no access-list outside_access_in extended permit object RDP any object HyperV 
access-list outside_access_in extended permit tcp any object HyperV eq 3389

 

HTH

Sandy

33
Views
5
Helpful
1
Replies