Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

HIgh CPU utilization alert

Hi,

i want to set high cpu utilization alert that has to recive by mail.

means i want to recive these alert on my mail.

can i do it using ASDM.

Asdm version 6.4

firewall 8.2

Regards,

Prashant

4 REPLIES

HIgh CPU utilization alert

Hello Prashant,

You could create a logging list and log the following messages to your email address:

%ASA-1-735007 CPU var1: Temp: var2 var3, Critical

•%ASA-1-735022: CPU# is running beyond the max thermal operating temperature and the device will be shutting down immediately to prevent permanent damage to the CPU.

%ASA-3-211003: CPU utilization for number seconds = percent

•%ASA-2-735023: ASA was previously shutdown due to the CPU complex running beyond the max thermal operating temperature. The chassis needs to be inspected immediately for ventilation issues.

I think the one you are going to check the most is the syslog ID:  211003

Remember to rate all the helpful posts

Julio

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
New Member

HIgh CPU utilization alert

Hi Julio,

could you please share a configuration example for cisco asa 8.2.

You can assume that my email address is xyz@gmail.com

Regards,

Prashant

HIgh CPU utilization alert

Hello Prashant,

Logging list CPU message 211003

Logging list CPU message 735022-735023

logging mail list CPU
logging recipient-address email_address
logging from-address email_address
smtp-server ip_address

"An SMTP server is required when you send the syslog messages in e-mails. Correct configuration on the SMTP server is necessary in order to ensure that you can successfully relay e-mails from the PIX to the specified e-mail client."

For further information

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805a2e04.shtml#use

Regards,

Julio

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
New Member

HIgh CPU utilization alert

Nice info, thank you

888
Views
9
Helpful
4
Replies