04-24-2009 10:34 PM - edited 03-11-2019 08:23 AM
Hi,
I have on my company two Vlan (192.168.1.0/24 and 192.168.2.0/24)but without switch layer 3 so without connection them.
Now, I need to give application Citrix installed on a host 192.168.2.8 at some client from network 192.168.1.0.
So I think to deploy an a PIX 501 and connect interface inside on 192.168.2.0 and interface outside on 192.168.1.0.
Does anybody advice me an configuration about or documentation ?
Best regards
Lorenzo
04-26-2009 01:50 AM
Lorenzo,
Do you have to secure the connections between the 2 vlans - are they both internal to your company?
04-26-2009 09:57 AM
Yes,
they are both internal in my company but different department and I need to connect application from a network with some clients in the other.
best regards
Lorenzo
04-26-2009 10:24 AM
The easiest way would be to create an SVI interface on your primary switching/routing device if you have one.
If not - a router that has interfaces in both vlans will route between the 2 is also a good solution.
Do you have a router?
Do you have a switch capable of supporting SVI's?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: