Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

How do I configure Multicast Bridging on FWSM with multiple context.

Hi There

Can't find any information regarding this feature, what I have found states that it is a feature, which only is supported when Your context is running in transparent mode, is that true. ???

Thanks in advance.

2 REPLIES
Cisco Employee

Re: How do I configure Multicast Bridging on FWSM with multiple

Currently we

only support multicast routing in the single routed mode. It is not

supported in multi-context mode. We do support multicast bridging, but

this would require transparent mode versus routed(only need to allow

multicast traffic via an ACL then). In addition, the

multicast routing is limited to 8 interfaces.

I hope it helps.

PK

New Member

Re: How do I configure Multicast Bridging on FWSM with multiple

Hi PK

Thanks for Your reply.

I have recommended 2 approaches to my

costumer.

Ad 1.

Move the clients that are to receive the multicast traffic onto the VLAN with the Multicast servers.

Ad 2.

I can build a setup with a seperat set of PIX hardware to move the multicast traffic onto the costumers secure network.

623
Views
0
Helpful
2
Replies
CreatePlease to create content