Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I Debug the config - add break points

Hi,

Is it possible to debug a ASA config?

For example, when you write a program in Java you can debug (add break points) at each command to see where the config is incorrect, is there such a way to do this on a ASA?

4 REPLIES
Silver

How do I Debug the config - add break points

John Peterson wrote:

Hi,

Is it possible to debug a ASA config?

For example, when you write a program in Java you can debug (add break points) at each command to see where the config is incorrect, is there such a way to do this on a ASA?

Not that I know of.

However, when you're entering a config via the CLI, the system will tell you if you use incorrect syntax, or have a glaringly obvious error.

It's enough to work through probably 70% of config issues.

Someone might know an off-line configuration parser, but I've never seen one.

Cheers

New Member

How do I Debug the config - add break points

Ok, thanks.

Would you know in which order the command are  excuteded .i.e. ACL,NAT,VPN etc...

Bronze

Re: How do I Debug the config - add break points

Hi,

Depends on the direction of traffic

If inside to outside then acl and then nat

Keeping above with VPN tunnel then inside acl , nat and then VPN acl

HTH

Sent from Cisco Technical Support iPad App

New Member

How do I Debug the config - add break points

Is there anything else which is between "inside to outside then acl and then nat" ?

Does the VPN commands get excuteded just before the packet goes out the outside interface?

Thanks

250
Views
0
Helpful
4
Replies