Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

How do i open up a port on my firewall?

I have a ASA 5520 and i need to open up port 1500. Can anyone help me on how to do that?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How do i open up a port on my firewall?

What I dont know is if you want to specify a destination or not, I assume to any destination in the access-list

access-list name permit tcp host 172.16.108.10 any eq|gt 1500

3 REPLIES

Re: How do i open up a port on my firewall?

Hey:

If I understood well, you wanna create a rule that the port be greater than 1500, right?. If so, via CLI you have to add gt 1500 at the end of the access-list, via CLI you have to write >tcp/1500.

HTH,

Francisco

Community Member

Re: How do i open up a port on my firewall?

ok, so what would my command be if i wanted to give access to IP address 172.16.108.10 access to port 1500? Sorry i am still learning the access lists... thank you for helping so far

Re: How do i open up a port on my firewall?

What I dont know is if you want to specify a destination or not, I assume to any destination in the access-list

access-list name permit tcp host 172.16.108.10 any eq|gt 1500

420
Views
0
Helpful
3
Replies
CreatePlease to create content