How do I remove a single ACL line in a 2811 router?
I need to remove one line of code in a Cisco 2811 router, without removing the entire ACL. I'm used to making these changes in firewalls, but have figured out it's a little different in the router. Can someone provide me with some instruction? I heard I need to go into a sub-interface of the acl, but how do I do that?
Also, will making this change affect any traffic routing through this router?
Thanks for the help, I'm going to need to make this change within the next hour or so.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...