Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to avoid swap of ASA Management IP addresses in case of failover ?

We have 2 ASA 5525X V9.1.2 in active/passive failover mode; they are managed via their M0/0 interface

Is there a way to avoid that primary and secondary ASAs exchange their own IP addresses at time of failover ?

the objective is to allow each ASA to be always managed via the same IP address whatever their active/standby state ;

the "no monitor management" command only allows to avoid a failover to occur in case of failure of the management interface of the active ASA;

thank in advance for any help

2 REPLIES
Cisco Employee

Hi,No  , this will not be

Hi,

No  , this will not be possible. This is because every component of the configuration will  be replicated.

Thanks and Regards,

Vibhor Amrodia

New Member

ok, it's a pity ;thanks for

ok, it's a pity ;

thanks for you answer

62
Views
0
Helpful
2
Replies