I am new to ASA, we have ASA 5505 with Security Plus license. Please see attachment for Configuration. I am trying to do is route from interface (Vlan 1 - 10.0.0.0 inside) to Internal_LAN (vlan 3 -184.108.40.206) and vice versa
From each subnet I am able to connect to the internet, but I need these subnets to also be able to talk to each other.
I have each VLAN interface at security level 100 and enabled "same-security-traffic permit inter-interface"
remove this command...or...create NAT rules for traffic between the inside interface and AP interface.
this command is no longer in use in the newer versions of ASA. Originally it was placed in the configuration as an extra security measure, but I suppose it was found that it wasn't really needed so it was removed completely as of ASA 8.4.
So just issue the command:
and then test and let us know.
Please remember to select a correct answer and rate helpful posts
Please remember to rate and select a correct answer
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...