Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to config failover with only one global IP

Hi, I want config a failover for PIX515E. One site is finished because it has 5 global IP. But another site only has one global IP. I check the configuration sample, each PIX515E should has different global IP in outside. What can I do? Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: How to config failover with only one global IP

A quick and dirty fix is to put a small router / Layer 3 switch on the outside of your PIX, however this introduces another point of failure that is not redundant.

Your best course of action is to get some more IPs

Nick

1 REPLY
New Member

Re: How to config failover with only one global IP

A quick and dirty fix is to put a small router / Layer 3 switch on the outside of your PIX, however this introduces another point of failure that is not redundant.

Your best course of action is to get some more IPs

Nick

150
Views
0
Helpful
1
Replies
CreatePlease to create content