Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

How to configure Pix 515e vpn to Symantec vpn

Please can someone give me guide to configure cisco pix 515e for vpn to Symantec firewall:

The Symantec params:

DH group 1

Encryption : 3DES

Hash: md5

Urgent

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to configure Pix 515e vpn to Symantec vpn

Get 3DES/AES License to enable L2L vpn capabilities, once done refer to bellow link to configure the tunnel..

Sample config for l2l vpn, this is PIX to PIX using 7.x code but same principle if running 6.x code, as far as your end is concern you need peer IP address and ipsec information you posted as well as destination host you will be connecting to behind the other end to build tunnel access-list.. but mostly follow example bellow.. if problems after configuration let us know.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805a87f7.shtml

Pls rate any helpful post !

HTH

Jorge

1 REPLY

Re: How to configure Pix 515e vpn to Symantec vpn

Get 3DES/AES License to enable L2L vpn capabilities, once done refer to bellow link to configure the tunnel..

Sample config for l2l vpn, this is PIX to PIX using 7.x code but same principle if running 6.x code, as far as your end is concern you need peer IP address and ipsec information you posted as well as destination host you will be connecting to behind the other end to build tunnel access-list.. but mostly follow example bellow.. if problems after configuration let us know.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805a87f7.shtml

Pls rate any helpful post !

HTH

Jorge

141
Views
0
Helpful
1
Replies
CreatePlease to create content