Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to copy contents of ASA 5510 to another ASA 5510?

Hello,

I want to copy contents of 1 ASA 5510 to another 5510.

Both ASA has same license.

-I tried to connect to 2nd ASA via console cable

-Went to "Conf t" and copied config of 1st ASA. [ using paste tab from Hyper Terminal ]

- used commands like copy running config disk0:/startup.config.cfg

- also used write memory all , wr mem commands

- But after reboot config was gone.

As of now I have ASA 8.3.x version in both ASA's.

How can I save config to 2nd ASA via Hyper Terminal?

3 REPLIES

How to copy contents of ASA 5510 to another ASA 5510?

It would be easist if you used ASDM and did a full backup then restore it to the second ASA. That would copy everything including any certificates, custom profiles, AnyConnect clients, etc.

New Member

How to copy contents of ASA 5510 to another ASA 5510?

I am trying to save basic config.

Basic config also not getting saved.

Steps followed as follows :-

- Given private IP to eth 0/1

- no shut

- speed auto

- wr

- exit

- wr

- exit

- hostname asasec

- wr

- reload

After reload firewall is not saving configuration.

Re: How to copy contents of ASA 5510 to another ASA 5510?

Hi,

Kindly post 'show version' output. Make sure the config register is 0x1.

Issue a 'no configuration-register' command if it's not.

Sent from Cisco Technical Support iPhone App

204
Views
0
Helpful
3
Replies
CreatePlease to create content