I tried creating a privilege 0 account for a client for read-only access to their ASA firewalls. For the CLI login, it won't matter cause they don't know the enable password, so that keeps them from making changes. But for the ASDM login, I was able to login with the privilege 0 account and make changes to the device (adding users).
I searched cisco.com and of course I found nothing good.
Should I create some 'privilege level 0' commands? I looked at that command and I didn't see anything to specify ASDM read only.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...