Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How to create Virtual Interfaces on a PIX 525

Hi,

Does any have any information about how to configure a virtual interface on a physical interface?? Actually I am a bit new to PIX firewall and i need to implement it in my company....Firewall model is PIX525....so anybody having any idea of how to split 1 physical interface in to two logical interfaces?? as i have only two interfaces "Inside" and "outside" on the device but i have three different segments on my network namely, "inside", "DMZ" and "outside" now i want the "inside" interface of the device to carry the traffic for DMZ and inside from the same physical interface but seperately? how is it possible and also if inside and DMZ needs to communicate since they are on two different logical interfaces so would they require any static route for the cause?? if so what it would be??

1 REPLY

Re: How to create Virtual Interfaces on a PIX 525

You can trunk the inside interface to a switch and use two different VLANs, one for 'inside' and one for 'dmz'.

http://cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_book09186a0080172852.html

128
Views
0
Helpful
1
Replies
CreatePlease login to create content