is it possible to disable the ipv6 Access-List-Rules in ASDM? I have about ten interfaces, that are all double-displayed with an ipv6 implicit deny rule. I don't need this rules and it is a very confusing view of all access rules with the unneeded ipv6 rules. ipv6 is disabled on all interfaces.
Two years late, but I was looking at the same thing.
In ASDM version 6.6 (at least that is what I have in front of me), at the bottom of the middle pane that displays the rulesets, is an 'Access Rule Type' section, where you can specify IPv4 only, IPv6 only or both.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...