I am really newer for ciscopix. but I did attached configuration for pix. I have windows 2003 SBS ip address 192.168.23.6 behind pix. static nat to inside webserver from outside good working. but only not working from DHCP users of Windows server to own webserver.
How I can access it from DHCP users of Windows 2003 sbs. Please advise me.
if the DHCP users are assigned ip address in the range 192.168.23.X and they are connected to the same lan with the servers, then it's not PIX problem as in this case users requests are sent to the servers directly not through the pix.
To me it looks like you have some IP/Subnetting issues. You have a default route to 22.214.171.124, your static statement is 126.96.36.199 and your outside IP address is 188.8.131.52 with a 28 Bit Mask (255.255.255.240). I don't see how any of those are even on the same network, unless the subnet .240 is wrong. I'm assuming the .100 and .95 are wrong, as .95 is a broadcast address on the .80 subnet, the .100 is in the middle of the .96 subnet. The .225 seems logical because it's the first host on the .224 subnet so subesequent hosts would be 226, 227 through .238.
I could be looking at this wrong, but please double-check those items for me.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...