What are the steps needed to upgrade the image on a WS-SVC-FWM-1?
I'm trying to go from 3.1(5) to 3.2.(5). This blade is in a 6500e chassis with just a sup7203b 12.2(33) no configurations were made except for the ip address on interface on the sup engine to connect to my computer. I looked at the cisco docs and its real confusing I'm not sure how to configure an interface on the FWM blade to ping the tftp server.
You need to create and assign L2 VLAN(s) (with L3 SVI(s)) on the Catalyst to the firewall and then create corresponding interfaces on the FWSM. With that you should be able to log into the the FWSM IP address directly.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...