Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I need to create pat for all inside address ranges to the outside interface ip on Cisco ASA 9.1- Help!

I need to create pat for all inside address ranges to the outside interface ip on Cisco ASA 9.1- Help!

The inside address ranges are:

192.168.1.0  255.255.255.0

192.168.2.0  255.255.254.0

172.17.1.0  255.255.255.0

172.30.1.0  255.255.255.0

172.30.2.0  255.255.255.0

172.30.3.0  255.255.255.0

10.128.1.0  255.255.255.0

 

The outside address is:

24.103.202.x

I need to make sure its a pat that can accomodate all those addresses.

I knew how to do this with older versions of ASA with the global command. But those commands do not seem to work on ASA 9.1.

If you could help with a mock up config I would appreciate it.

 

Thanks.

KZ

 

 

1 REPLY
VIP Green

You could use a command like

You could use a command like the following:

object-group network SUBNETS

  subnet 192.168.1.0  255.255.255.0
  subnet 192.168.2.0  255.255.254.0
  subnet 172.17.1.0  255.255.255.0
  subnet 172.30.1.0  255.255.255.0
  subnet 172.30.2.0  255.255.255.0
  subnet 172.30.3.0  255.255.255.0
  subnet 10.128.1.0  255.255.255.0
  nat (inside,outside) dynamic 24.103.202.x

--

Please remember to select a correct answer and rate helpful posts

--

Please remember to rate and select a correct answer
48
Views
0
Helpful
1
Replies
CreatePlease login to create content