Identity NAT config from Destination to Source

[mahesh18]

Hi Everyone,

In one of Client Network Environment i need to config static Identity NAT below to fix the traffic flow from PC to server

statitc(X,Y) 192.168.3.1 192.168.3.1 netmask 255.255.255.255

Traffic flow from PC to server was below

PC was connected to interface Y of Firewall and Server was connected to interface X of Firewall.

Where 192.168.3.1 is server IP.

Need to confirm that above Identity NAT config is normal in network design?

Regards

Mahesh

[nkarthikeyan · Accepted solution]

Hi Mahesh,

This is similar to no-nat or nat exempt..... it can be done if the requirement is like this......

Normally we do this for a inside to dmz zone in most cases...... or denying access from un-trusted zones....

You can use that.... that should not be a problem....

Regards

Karthik

[mahesh18]

Hi Karthik,

Thanks for confirming that it can be config on networks.

Regards

Mahesh