Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

IKE Does Not Start

Hi,

I have an ASA5510. When I put the command 'crypto map MAP 20 set peer a.b.c.d', an error message "[IKEv1]: Ignoring msg to mark SA with specified coordinates <MAP, 20> dead" comes out. What does this mean?

When I turned out debug crypto isakmp 127, no messages come out.

How can I start IKE?

Thanks in advance.

2 REPLIES
Community Member

Re: IKE Does Not Start

Hi,

I am not sure about your full configuration, but if you want to enable ISAKMP on a specific intrface use the command:

Crypto isakmp enable interface_name

The ISAKMP should start when you define this, if this is not the case, post your config, and make some debugging, for isakmp and ipsec.

regards

Community Member

Re: IKE Does Not Start

Hi,

It starts working after a reload.

Thanks for your response

522
Views
0
Helpful
2
Replies
CreatePlease to create content