Implicit firewall rule

[Dave Kozlowski]

I am trying to setup access rule for an internal interface on a ASA 5020 and the ANY-ANY implicit rule set to Deny stops anything.  I have setup rules but this implicit rule is last an almost stops the traffic.  

Thanks

Dave

[Marius Gunnerud]

Would help to know what your are trying to permit and see what config you are implementing.

But, if it almost stops traffic, that would mean traffic is passing?

The implicit deny any any is at the end of all ACLs, and when setting up access restrictions you should configure the rules to be as specific as possible.

For more help please provide a more detailed description of what you are trying to do, and seeing the configuration of your ASA would also help.

--

Please remember to select a correct answer and rate helpful posts