Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Importing ASA CX module into PRSM

I went to import an ASA CX into PRSM and received the following error:

Invalid HA configuration: Failover LAN interface status is not 'up.' Please check that both the primary and secondary units are configured properly for failover, and that the LAN interface is active. If you want to import this device as a stand-alone unit, please use the 'no failover' command to turn off the failover configuration and try importing the device again.

 

The reason the ASA is in a failed failover status is because the other ASA came with a bad CX module.  What I need to know is if I change the ASA to standalone, what will I need to do in PRSM when the replacement arrives and I put the ASA's into an A/S pair?

 

TIA,

Dan

1 REPLY
Hall of Fame Super Silver

I'm not positive but I

I'm not positive but I believe you'd have to remove and then re-add the ASA + CX when you change mode from standalone to failover pair.

If you've requested a new unit via RMA it should normally arrive next business day so it'd be best to simply wait for it.

45
Views
0
Helpful
1
Replies
CreatePlease login to create content