Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Injecting default route in PIX

Hello,

I have a PIX 515 running version 7.2.2. I want to inject a default route on the inside and on the dmz only. How do I do this? I tried to use the default information originate command but it also inject the default route into the outside interface. Hhow can I do this without sendin the default route to the outside?

Thanks

Lorenz

  • Firewalling
2 REPLIES

Re: Injecting default route in PIX

Hi .. make sure you only enable OSPF on the interfaces you need.

network ip_address mask area area_id

for example if your inside IP address is 10.10.10.10 then you will configure

network 10.10.10.10 255.255.255.255 area 0

I hope it helps .. please rate it if it does !!!

New Member

Re: Injecting default route in PIX

Hello Fernando,

Thank you so much for your reply. my problem is with RIP (oh sorry i forgot to specify this one). If i try to use "default information originate" on the RIP config mode on PIX, I also get default information sent to outside. I only want to send it on the inside. I tried many attempts in the config but I still cannot make it. what should I do?

Lorenz

498
Views
0
Helpful
2
Replies
This widget could not be displayed.