Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Insert a access-list rule

Hi,

If I need to add a new rule in the middle of an exist ACL, do I have to re-write the whole ACL? Can I just add this rule to the right place based on access-list sequence number?

Thanks

1 REPLY
Silver

Re: Insert a access-list rule

If you are running 6.3 code, you can add access-list at any position you want. This can be done using "line no." in the access-list command. For eg. I can use following command to add access-list at porion 10 in the existing ACL of 20 lines:

access-list 101 line 10 permit ip any any

Hope this helps.

Regards,

Vibhor.

394
Views
0
Helpful
1
Replies
CreatePlease login to create content