Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
334
Views
0
Helpful
1
Replies

Installing Flashing Card Into ASA5520

asmith1972
Level 1
Level 1

‎09-03-2009 05:34 AM - edited ‎03-11-2019 09:12 AM

Hi We have two Cisco ASA5520 setup in Active / Failover mode. We are running low in memory on the primary and have ordered a extra 512MB Flash Card.

Anyway does anyone know if we have to do anything special to install this or can we just plug this into the front of the ASA while it is live? Or do we have to power down and power back up the box? Is there any commands we need to run for the ASA to see the extra memory?

Thanks

Labels:
0 Helpful
1 Reply 1

August Ritchie
Level 1
Level 1

‎09-03-2009 12:51 PM

I am assuming this is the user flash (external) and not system flash (internal). The user flash can be installed while live. To check that it is there do a "dir disk1:"

Also in the "show ver", there should be another flash field for external flash.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card