Do i have to use the Management port to configure the CX module, also is there any other way to access the ASA 5515 CX module other than accessing it via managemnt port, i dont want to terminate the management port on to my l2 swithc . But the issue is I am configuring the ASA remotely , I can access the ASA but not the CX module,
Other than the minimal initial setup that you do from the ASA itself, all of the PRSM-based configuration (policies etc.) must be done via login to the management port. This applies whether using the built-in PRSM ("on box") or an external PRSM server ("off box").
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...