I go a 30 day trial code for the cisco ios content filtering for use with Cisco 861w. However, I am not able to configure the content filtering with either Cisco Configuration Professional (CCP) or CLI. I have downloaded the latest IOS image but that still did not help.
Cisco IOS Content Filtering is supported on theAdvanced IP Services image in the Cisco 800 series and Advanced Security image and higher on Cisco 1800, 2800, and 3800 series platforms. Make sure you are running Advanced IP Services image that is 12.4.20T or later.
Thanks, yes I did register a trial code with Trend. but I had 12.4.24T2 on the router before, and that did not seem to "enable" the IOS Content Filteri
i did another test, on a cisco 1941w. this time i did not register anything with Trend, i just wanted to see if Content Filtering command (parameter-map type trend-global global-param-map) is available. They were available on the 1941w. I also went into CCP to check if the web filter configuration is availabe for the 1941w, and it was. 1941w is running c1900-universalk9-mz.SPA.150-1.M2.bin
i looked online and found that Cisco IOS Content Filtering is only supported on 881 and 888.
Cisco 800 Series Integrated Services Routers come standard with:
4-port 10/100 Mbps managed switch
Security features, including Cisco IOS Firewall set
In addition, the Cisco 871, 876, 877, 878, 881, and 888 models include:
Intrusion prevention with advanced IP services
Cisco Dynamic Multipoint VPN, Cisco GETVPN, and SSL VPN Solutions
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...