Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IP Address Change on PIX 506E

I am trying to change IP address of the inside intreface and here is the message that I am receiving. I tried changing the DHCP pool first without success.

BOSS(config)# ip address inside 192.168.3.1 255.255.255.0

Interface address is not on same subnet as DHCP pool

BOSS(config)# dhcpd address 192.168.3.2-192.168.3.100 inside

Address range subnet is not the same as inside interface

4 REPLIES
New Member

Re: IP Address Change on PIX 506E

i ran into this before also. the Pix would not let me do this because the interface was up. Once I shut it down, I removed both inside and outside IP address configs and put them back in. Good luck.

Silver

Re: IP Address Change on PIX 506E

Remove the pool the change the IP. Re-add the Pool.

Hope this helps!

Chad

New Member

Re: IP Address Change on PIX 506E

I got around it by clearing the DHCP pool first and entering new inside IP.

clear dhcpd

Thanks!

New Member

Re: IP Address Change on PIX 506E

disable the DHCP

remove the DHCP pool

change the inside IP address

recreate the DHCP pool

reenable the DHCP

write to mem

then reload

this is the only way that I was able to change the inside IP address while it was running and the DHCP was enabled. Works every time

885
Views
0
Helpful
4
Replies