Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ip address outside and ip address inside

i am trying to setup a new pix firwall (525). i named the inside and the outside interfaces and set the security level on them , but when i try to assign an ip address for the inside and the outside the command fails, has anyone experienced this issue. any ideas, thanks.

3 REPLIES
Silver

Re: ip address outside and ip address inside

Hi,

we will need more info. What error do you get when you try to configure ip address?

regards

John

New Member

Re: ip address outside and ip address inside

the error i get is :

pixname(config)# ip address outside A.B.C.C 255.255.255.0

^

ERROR: % Invalid input detected at '^' marker.

the same error for inside or outside.

Also when i try to type ip address ? there is no outside or inside option from the ? mark.

Silver

Re: ip address outside and ip address inside

hi,

what version of PIX os are you running? if you are running version 7.x or 8.x then you need to be in interface configuration i.e.

pixname(config-if)#

regards

John

283
Views
0
Helpful
3
Replies
CreatePlease to create content