Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

IP Change Outage

I'm looking for a procedure to minimize the outage of changing the "inside" NIC IP of active/standby ASA. Can someone give me some hinters?

1 REPLY

Re: IP Change Outage

Norman,

I would schedule a down time slot of about oooooh 5 seconds (depending no your nearest layer 3 device), attach my console cable to the back of the primary - configure on your inside interface the command:-

ip address x.x.x.x y.y.y.y standby z.z.z.z

(also depending on your failover config/requirements)

As long as your/if you are using it:-

failover link failover <>

failover interface ip failover <> <> standby <>

does not change - can't see an issue!

Oooo and wr mem - to sync the configs of course!

HTH>

137
Views
0
Helpful
1
Replies
CreatePlease to create content