Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

D
New Member

IPSEC problem between Cisco Router and Netscreen 5GT

isakmp is working.

fase 2,Ipsec does not work:

IPSEC(validate_proposal): transform proposal (prot 3, trans 3, hmac_alg 1) not supported

1 REPLY
Silver

Re: IPSEC problem between Cisco Router and Netscreen 5GT

To my knowledge, the problem might be the transform set mismatch or the tunnel group mis match name.

This document provides an explanation of common debug commands that are used to troubleshoot IPsec issues on both the Cisco IOS? Software and PIX. It is assumed that an attempt to configure IPsec is completed. Refer to Common IPsec Error Messages and Common IPsec Issues for more details.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_tech_note09186a008009448c.shtml

132
Views
0
Helpful
1
Replies