Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPSec Tunneling informations needed

I have a Watchguard Firebox 3 in a remote site and a PIX 515e on my local site and want to have them communicate each other via a IPsec Tunnel and I don't really know how to perform that!

Does anyone can tell me the path ?

Thanks

3 REPLIES

Re: IPSec Tunneling informations needed

Hi Guy, I could not comment on the Watchguard Firebox firewall on the how to stablish a vpn tunnel between two sites, however, you can take a look at some examples on how to configure site-to-site vpn between two pixes, read the principle on site-to-site vpn tunnel and you could get some support from the firebox vendor on how to create a site to site tunnel on their boxes.

Example of lan-to-lan vpn tunnel (CLI )

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094761.shtml

Example of lan-to-lan vpn tunnel (PDM )

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008055bd85.shtml

Also, for the PIX515 side ensure you have

proper VPN-3DES-AES license as this is needed to enable site to site vpn tunnels.

HTH

Jorge

New Member

Re: IPSec Tunneling informations needed

Thanks Jorge,

I already have the proper VPN-3DES-AES license since I have installed a tunnel between our Europe Office and North America one. Thanks for the suggestion. I will have a look on Whatchguard side.

Re: IPSec Tunneling informations needed

No problem,let us know how you make out on the watchguard fw side and pix tunnel.. check this forum as there is always a posibility someone out there may have done it and post comments on this thread..

Rgds

Jorge

122
Views
0
Helpful
3
Replies
CreatePlease to create content