Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPV6 and failover 8.0.4

Hi,

we are getting the following messages in our PIX with 8.0.4 SW version:

%PIX-6-110002: Failed to locate egress interface for UDP int_inside:IPV6add to IPV6add2

%PIX-6-110002: Failed to locate egress interface for TCPint_inside:IPV6add to IPV6add2

this only happens when we have the PIXs in failover, if we put it in standalone both work without this problem..

failover it's already supported with IPV6 configured?

Thank you.

5 REPLIES
Cisco Employee

Re: IPV6 and failover 8.0.4

Norberto,

IPv6 failover is supported as of ASA (not PIX) version 8.2.2

Do you receive those messages on active unit?

Marcin

New Member

Re: IPV6 and failover 8.0.4

We have the failover configured in ipv4 but we are using ipv6 also..is failover unsupported in this scenarium? Or it's just unsupported if we have the failover configured with ipv6 addresses?

Cisco Employee

Re: IPV6 and failover 8.0.4

Norberto,

Before 8.2.2 both active and standby unit were using same IPv6 address which is already quite interesting for say management purposes

Marcin

New Member

Re: IPV6 and failover 8.0.4

But in double-stack (with the failover configured with ipv4) it's this supported?

Cisco Employee

Re: IPV6 and failover 8.0.4

If you're aware of the limitations I don't think anyone will claim it's not supported.

256
Views
0
Helpful
5
Replies
CreatePlease login to create content