Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Is PIX Failover possible without using 2 IPs?

I have a PIX in routed mode. I have another one exactly the same plus the serial failover cable.

The problem is that in order to use Active/Standby configuration I need to use 2 IP per interface (Active and standby).

Unfortunately my networks use real IPs with /30 mask so I don't have any free IPs to use for the standby IP.

I searched and couldn't find anything.

I know this is a long shot, but does anyone know of any way to implement PIX failover without using a 2nd IP?

1 REPLY
Community Member

Re: Is PIX Failover possible without using 2 IPs?

Its not possible with active/standby configuration

101
Views
0
Helpful
1
Replies
CreatePlease to create content