Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)

is there a "conversion tool" to convert 6.3 config to 7.0 config on Pix

i have up dated my backup pix from 6.3 to 7.0, there were a few error messages from the config.

is there a tool availble that you can input the 6.3 config and it produces the 7.0 config, so we can correct any possible errors before the live conversion?

2 REPLIES

Re: is there a "conversion tool" to convert 6.3 config to 7.0 co

Hi,

There's no tool to convert PIX 6.x to ASA 7.x configuration. When a Pix is upgraded from 6.x to 7.x SW automatically does that for you, looking at "show start error" output after upgrade will tell if there are any commands which are not converted.

Regards,

~JG

Community Member

Re: is there a "conversion tool" to convert 6.3 config to 7.0 co

127
Views
0
Helpful
2
Replies
CreatePlease to create content