Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISIS ACL

I'd like to know how can I configure a ACL to permit the isis routing protocol?

In the acl there is no ISIS like OSPF

1 REPLY
Silver

Re: ISIS ACL

The ISIS protocol use protocol identifier of 0x83, it is a layer 2 identifier. IS-IS does not run over IP. You would need to use an ACL in the 200-299 range, matching on the L2 Protocol type.

You might look into the CLNS filters to do this.... 'clns filter-expr' and 'clns filter-set'.

Refer this link:

http://www.cisco.com/en/US/products/ps6350/products_command_reference_chapter09186a0080449b9a.html#wp1018279

300
Views
0
Helpful
1
Replies
CreatePlease login to create content