Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Issue with ASA

We have upgraded a pair of ASA 5540 with Version 8.0(2)? recently.

The problem we are facing is as below:

1. NAT Exemptions {nat (INSIDE) 0 access-list no_nat_in } does not get communicated to the failover pair.

2. Also if reloaded the nat exemption (nat 0) command gets deleted automatically and have to be then manually configured again.

3. Also if there are access-lists for the nat exemption are already configured and we try to configure the ?nat 0? it fails with a error message ?ERROR: access-list has protocol or port? the remedy of which is to remove all the no_nat access-lists, then configure single line, then configure the nat 0 statement and lastly put the remaining access-list lines.

Is this a bug issue?

Thanks in adv.

102
Views
0
Helpful
0
Replies