Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Juniper to Cisco application layer gateway

Hi There

I'm busy converting juniper to Cisco line by line I've used the Cisco tool but had some errors that I'm now fixing manually. how do I convert the Juniper application layer gateway to a Cisco ASA format, see below.

The (set policy id 663 application "FTP")  command is my problem

set policy id 663 name "110307-000124" from "Trust" to "VPN"  "SS-AGSERVICES" "SS-SERVERS" "FTP" permit log
set policy id 663 application "FTP"

 

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi,On the ASA device , you

Hi,

On the ASA device , you don't have to explicitly specify the Layer 7 policies.

You only need to enable the inspection for that specific protocol.

Thanks and Regards,

Vibhor Amrodia

1 REPLY
Cisco Employee

Hi,On the ASA device , you

Hi,

On the ASA device , you don't have to explicitly specify the Layer 7 policies.

You only need to enable the inspection for that specific protocol.

Thanks and Regards,

Vibhor Amrodia

69
Views
0
Helpful
1
Replies
CreatePlease to create content