Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Juniper to Cisco config conversion issue

I am trying to convert a Juniper to Cisco config, I've used the online tool however I got a lot of errors showing the line that the tool could not convert. I'm working on the below at the moment. is there a way to configure the UUID on an ASA or how do I go about converting these?

 

could not convert line # 222 from xxxxx.txt
%set service "svc-RPC-MS-SSIS" + ms-rpc uuid 552d076a-cb29-4e44-8b6a-d15e59e2c0af
%ERROR REASON: The protocol defined here is not supported in Cisco service objects, Hence ignoring this line.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi,You would not be able to

Hi,

You would not be able to filter the DCE-RPC traffic on the basis of a UUID value. This should not be needed to be configured on the ASA device.

You just need to enable the DCERPC inspection.

Thanks and Regards,

Vibhor Amrodia

 

 

2 REPLIES
Cisco Employee

Hi,You would not be able to

Hi,

You would not be able to filter the DCE-RPC traffic on the basis of a UUID value. This should not be needed to be configured on the ASA device.

You just need to enable the DCERPC inspection.

Thanks and Regards,

Vibhor Amrodia

 

 

New Member

ThanksI also came across the

Thanks

I also came across the below config guide in the process.

http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/inspect_mgmt.html#wp1478733

 

164
Views
0
Helpful
2
Replies
CreatePlease to create content