Juniper to Cisco config conversion issue

[CSC011240286]

I am trying to convert a Juniper to Cisco config, I've used the online tool however I got a lot of errors showing the line that the tool could not convert. I'm working on the below at the moment. is there a way to configure the UUID on an ASA or how do I go about converting these?

could not convert line # 222 from xxxxx.txt
%set service "svc-RPC-MS-SSIS" + ms-rpc uuid 552d076a-cb29-4e44-8b6a-d15e59e2c0af
%ERROR REASON: The protocol defined here is not supported in Cisco service objects, Hence ignoring this line.

[Vibhor Amrodia · Accepted solution]

Hi,

You would not be able to filter the DCE-RPC traffic on the basis of a UUID value. This should not be needed to be configured on the ASA device.

You just need to enable the DCERPC inspection.

Thanks and Regards,

Vibhor Amrodia

[CSC011240286]

Thanks

I also came across the below config guide in the process.

http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/inspect_mgmt.html#wp1478733