im trying to configure lan based failover on ASA 5510 (which ive sucessfully created in test lab using asa5510) but there is this strange issue where i cant ping the e0/3 interface prior to confiuring the failover.
So far, ive created a vlan 41 on a cisco 2960switch and placed inter g0/12 (which is conencted to primary ASA e0/3 which i will used as the failover interface into that vlan. the ip add of e0/3 is 192.168.254.1/24
Then, ive placed inter g0/11 (which is connect to secondary asa inter e0/3) into vlan 41 with interface ip of 192.168.254.2/24.
Now prior to entrering the relevant failover commands, i should be able to ping at least the e0/3 interfaces on both ASA's? well i cant.
Ive checked the speed and duplex settings on asa's and switch and all set to 100MB full.
sh vlan brief output:
41 VOICE_FAILOVER active Gi0/11,Gi0/12
sh interface status
Gi0/11 connected to SupAS connected 41 full 100 10/100/1000BaseTX
Gi0/12 connected to SuppA connected 41 full 100 10/100/1000BaseTX
sh interface e0/3 (ASA 1)
Interface Ethernet0/3 "", is up, line protocol is up
Hardware is i82546GB rev03, BW 100 Mbps
Full-Duplex(Full-duplex), 100 Mbps(100 Mbps)
Available but not configured via nameif
MAC address 001e.f762.c8b3, MTU not set
IP address 192.168.254.1, subnet mask 255.255.255.0
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in HA
DocumentationCode download linksGoalRequirementLimitationsSupported ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and UCS-E Blades:Step by Step ConfigurationCo...
I am currently unable to specify "crypto keyring" command when configuring VPN connection on my cisco 2901 router.
The following licenses have been activated on my router :