Quick question about this state change reason. We had an FWSM, in a two chassis redundancy configuration, recover from a reload and it went from state Not Detected to Disabled due to LAN Interface become un-configured. I have a sneaking suspicion that this is a vlan sync issue but I was hoping someone could shed some light on whether "LAN interface" refers to any interface in particular or is it referring to just one of the many interfaces on the FWSM?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...