Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Licensing ASA Firepower Module

I need to license the Firepower module features on a 5508.  I am going to manage this with the ASDM. In the license portal I have added the PAK for AMP, IPS, and URL and it shows as "Unfulfilled".  I then choose it and click "Get License" and I am stepped through a process which at which the next screen says "Assign to Target Device" but below is prompting me for a License Key.  What am I supposed to enter?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Licensing ASA Firepower Module

3 REPLIES
Highlighted

Re: Licensing ASA Firepower Module

During the process it should have prompted for you to enter the UID. Have you got that far?

Re: Licensing ASA Firepower Module

Community Member

Re: Licensing ASA Firepower Module

Not very intuitive, but thanks that was what I needed.

459
Views
0
Helpful
3
Replies
CreatePlease to create content