Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Load Balance with ASA using RIP

Hi Guys,

a company asked me to do the following scenario,

2 routers connected to 2 different ISPs connected to layer 2 switch & they are using RIP, the switch should be connected to the ASA, and i suppose to configure the ASA using RIP dynamic routing instead of default route... (for outside)

any limitation or problems in this scenario?, i heard that using RIP on the ASA may make issues...

please advice..

Regards,

3 REPLIES
Community Member

Re: Load Balance with ASA using RIP

hi

as far as i know you cant run RIP on ASA, just OSPF.

Community Member

Re: Load Balance with ASA using RIP

Hi solpandor,

on PIX version 8 you can run RIP, so, by default ASA will be supporting RIP

Community Member

Re: Load Balance with ASA using RIP

As a curiousity ,

How are you planning to do it?

Vlad

133
Views
0
Helpful
3
Replies
CreatePlease to create content