Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Load Balancing on ASA 5510

Hello All,

I am having only Cisco ASA 5510 in my network. I am also having 2 Internet links. I want to use one link For Site-to-Site VPN & other Link for Internet.

So i need to do Load Balancing on ASA.

Is ASA 5510 Supports Load Balancing ?  if not whts the Other option ?

If Yes then How to do it ?

Thanks...

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Load Balancing on ASA 5510

Vinayak,

We have seen this question posted many times in the past. I had written a document to refer people to.

You can read about other options available here; https://supportforums.cisco.com/docs/DOC-13015

let us know if you have any further question, otherwise pls. mark this thread answered.

-KS

6 REPLIES
Bronze

Re: Load Balancing on ASA 5510

Hi

Please find below the link for your help and referrence.

http://www.cisco.com/en/US/docs/security/asa/asa71/asdm51/selected_procedures/asdm_lb.pdf

Also the same question was asked on this forums and I suggest you go through it

https://supportforums.cisco.com/thread/228769

HTH.

New Member

Re: Load Balancing on ASA 5510

Hi,

Thanks for reply.

According to the link it says Load Balancing is possible only on ASA 5520 or Higher.

But i am having ASA 5510. Then how to do Load Balancing on ASA 5510 ?

Am i require Router in this case ?

Cisco Employee

Re: Load Balancing on ASA 5510

Vinayak,

We have seen this question posted many times in the past. I had written a document to refer people to.

You can read about other options available here; https://supportforums.cisco.com/docs/DOC-13015

let us know if you have any further question, otherwise pls. mark this thread answered.

-KS

New Member

Re: Load Balancing on ASA 5510

Hi KS,

Thanks for reply.

According to this document. i got a brief idea. Means i need to install a router in my network, there is no other option.

Is this configuration is sufficient or i need to add some config in that. coz i want to use one link for site-to-site VPN only.

Cisco Employee

Re: Load Balancing on ASA 5510

If this is just for VPN to use one ISP and the rest of the traffic to use another ISP you can do that without a layer 3 device.

Terminate the tunnels to one interface (call it VPN interface) and use nat/global and your default route pointing to the other interface (call it Internet interface).

Add static routes to the peers via the VPN interface. Apply the crypto map only to this VPN interface.

-KS

New Member

Re: Load Balancing on ASA 5510

Hello KS,

yes, I want to usse one ISP only for VPN & Other ISP Only for Inetrnet. I want all my LAN User to use both these services at same time.

Can u tell me how to configure it on firewall.

I got ur point tht dedicating one interface for VPN. But can u please tell me how to do that ?

1649
Views
0
Helpful
6
Replies