Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Load balancing on ASA

Hello,

Can i load balance may traffic using single security appliance (ASA)

Thank YOu

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Load balancing on ASA

New Member

Re: Load balancing on ASA

Hi Gents,

but in this case ONLY one ISP is active at the time and the other is idle.

but if u require a load balance between two ISPs, I believe one more router needed to connect to the FW and configure a route-map for load balancing.

4 REPLIES

Re: Load balancing on ASA

could you be more concrete.

What are you going to do?

New Member

Re: Load balancing on ASA

Suppose i have an ASA in my netowrk, can i terminate two ISPs on my appliance? Also those connetions should provide load balancing in an active-active manner, if one goes down other should carry the entire traffic.. Is it is possible, if so Which among the ASA 5500 series will support these features..?

Re: Load balancing on ASA

New Member

Re: Load balancing on ASA

Hi Gents,

but in this case ONLY one ISP is active at the time and the other is idle.

but if u require a load balance between two ISPs, I believe one more router needed to connect to the FW and configure a route-map for load balancing.

170
Views
0
Helpful
4
Replies