Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Load Share in ASA

Hi,

I am using ASA 5520.Is it possible for me to terminate 2 or more than that isp on and run it as load share and failover?Failover can be worked out with two isp..I want to use it as load hsare and aggregation too.If not is there any alternate solution or product this?

Reg,

Sushil

5 REPLIES

Re: Load Share in ASA

You really should routers for this.

Community Member

Re: Load Share in ASA

How this has to be done.any link or url for the same would be appriciated.Here to differnet isp would be terminating the link on separate routers.A third link is coming as broadband connection.

Till now there was only one link from one ISP.terminted on router and that in turn attached with one of the int of asa,natted.How should be design if more isp comming.

Reg,

Sushil

Re: Load Share in ASA

Will you be running BGP or just getting default routes from each provider?

Community Member

Re: Load Share in ASA

Will be on defualt routes.

Re: Load Share in ASA

Simple load balance-

ip route 0.0.0.0 0.0.0.0 ISP_A

ip route 0.0.0.0 0.0.0.0 ISP_B

ip route 0.0.0.0 0.0.0.0 ISP_C

145
Views
5
Helpful
5
Replies
CreatePlease to create content