logging - how to stop console logging

[robert6755]

IOS 7.05 PIX 515e

I have turned on logging.

I set up a syslog server.

But log messages stop me from doing anything on the console.

How do I stop the messages?

I have tried "no logging console".

I tried setting "logging console 0"

I don't want to just limit the messages. I want to stop them completely when I am doing work. But not turn off logging to my syslog server.

[Collin Clark]

no logging console stops the messages from being echoed to the console (still sent to syslog). Are you consoled in or telnet/SSH?

[acomiskey]

If using telnet/ssh try no logging monitor.

[sivakondalarao]

Hi,

what is the status.

regards

skrao

[robert6755]

I am in Console. I attempted "no logging console"

That did not work but ....

If found this statement in a show running-config

logging class session console informational

I then put in

no logging class session console informational

This disable console logging and said so in the

show logging output.

Thanks

[robert6755]

no logging console works if I remove ...

logging class session console informational

with a

no logging class session console informational

[fairfaxMitchell · Accepted solution]

FIXEDL no logging console works if I remove ...

logging class session console informational

with a

no logging class session console informational

[mnandira@cisco.com]

this works for me too with Catalyst 9800 controller I was facing the same issue .. 

command is : no logging console informational 

but you need to be in "config t" mode for this to work ... 

[kaleemullahbilal1]

Thanks for the reply

I got the logs only when connect to Switch using console cable, tried to RUN the above command but still same.

[mnandira@cisco.com]

What kind of switch you are using ? 

and when you say "I got the logs only when connect to Switch" ==> What do you mean by that ? 

[HinokYohannes]

Thanks. Works on CISCO IOSvL2 images on GNS3.

[husycisco]

I assume logging class session console informational

command is dominant over all

[kaleemullahbilal1]

Switch is not accepting this command

[kaleemullahbilal1]

Consoled